Expansion Joint Seal

Part Number

Part No.

Length (m)

APEM0136

3.65

Expansion Joint Seal Installation

The Expansion Joint Seal is designed to fit directly into a pre-determined gap, depending on the chosen type of joint seal.

This seal requires no type of fixing or bonding solution to hold it in place. It is recommended that a survey is carried out of the expansion gap to determine the width, depth, any obstruction that may affect the fitting of the seal.

Traffic calming joint seal. The simple to fit design utilises existing expansion joints in roads and parking garages.

Benefits

  • Made from EPDM materials which resist oil, salt and ozone attack
  • Fits into expansion joints 60mm to 100mm wide
  • Assumes the camber of the surface it is fitted to
  • Four co-extruded yellow stripes ensure high visibility
  • Minimal fitting equipment required
  • Weather resistant and suitable for most climatic conditions
APEM0136 Expansion Joint Seal Expansion Joint Seal 2 Expansion Joint Seal 2a

Part Number

Part No.

Length (m)

APEM0336

3.65

Expansion Joint Seal Installation

The Expansion Joint Seal is designed to fit directly into a pre-determined gap, depending on the chosen type of joint seal.

This seal requires no type of fixing or bonding solution to hold it in place. It is recommended that a survey is carried out of the expansion gap to determine the width, depth, any obstruction that may affect the fitting of the seal.

A simple to fit design which provides an expansion joint seal for pedestrian walkways and light vehicles.

Benefits

  • Fits into expansion joints 60mm to 75mm wide
  • Assumes the camber of the surface it is fitted to
  • Four co-extruded yellow stripes ensure high visibility
  • Minimal fitting equipment required
  • Weather resistant and suitable for most climatic conditions
  • Made from EPDM materials which resist oil, salt and ozone attack
APEM0336 Expansion Joint Seal Expansion Joint Seal 3 Expansion Joint Seal 5